Brushless Motor Controller for 12V-36V 500W 15A Hall BLDC Motor Balanced

Description

Brushless Motor Controller for DC 12V-36V 500W 15A Hall BLDC Motor Balanced
Features: brand new and high quality
Motor driver board 12-36V for DC power input , VCC positive power supply,GND power supply is negative.
Pulse speed signal: high and low output . IC can not understand the information with the customer request
This board has many functions such as stall for protection, enable control, over-current for protection, steering control and speed control signal.
This driver board has many advantages including low consumption, high reliability and efficiency.
Electrical wiring: three-wire brushless for DC motor, corresponding to MA/U, MB/V, MC/for W
Tip: If you use a heat sink smaller than 60W and no additional heat sink, you must add a heat sink above 60W. If the driving efficiency of the heat sink is not reduced, excessive temperature will cause sexual damage!
Specifications: Operating voltage: for DC 12V-36V
Operating Current: <=15A
Driver Power: <=500W
Speed Voltage: 0.1V-5V
Operating Temperature:-40-85C
Humidity: 90%RH
Stall protection:Yes
Enable Control: Yes
Over-current protection: Yes
Steering control: Yes
Speed control signal: Yes
Size: approx 63x42.5x17mm/2.48x1.67x0.67in
Power terminal Out:
VCC(positive power supply)
GND(negative one)
MC(motor phases for W)
MB(motor phases V)
MA(motor phase U)
Set for the control side:
GND control terminal ground
VR the governor end 0-5V
ZF reversing control
for M tachometer pulse output
EL enable control terminal
Package Includes: 1x 12-36V 500W Brushless Motor Controller
note: Due to the problems of lighting effects and shooting angles, there will be certain tolerances in the product, please understand.
Please allow 0-1cm error due to the manual measurment.
Due to different motor manufacturers to make the hall of hall line order does not necessarily follow the line on the board to match the sequence, need to be adjusted, please parents who pay attention! If the line sequence wrong, does not boot properly, current, or start other phenomena not open, forced to use the drive plate will burn!!!